Go back

ProtectGuard® Wet Look

Water and oil-repellent, stain protection with a flat or shiny wet look

ProtectGuard® Wet Look is designed to protect mineral porous building materials against water, oil and staining. It protects against the main causes of deterioration such as atmospheric pollution and grease-based stains. A surface treated with ProtectGuard® Wet Look will be easier to care for and will be protected over time.

ProtectGuard┬« Wet Look gives treated substrates a flat ÔÇśwet lookÔÇÖ finish that enhances the original colour.

ProtectGuard® Wet Look allows the substrate to remain permeable to air and water vapour. It is UV-resistant and does not yellow.

  • Beading effect
  • Floors, facades
  • Coverage (1L = 10m2)
Advantages
  • Protection against water, oil and stains
  • Gives a flat or glossy wet look finish
  • Good resistance to abrasion
  • Lets the material breathe
  • Delays ageing and makes maintenance easier
USE
  • Porous materials: natural stone, terracotta, brick, concrete, etc.
  • Floors and facades
  • New or old
  • Interior or exterior
Back to the list
Advantages
  • Protection against water, oil and stains
  • Gives a flat or glossy wet look finish
  • Good resistance to abrasion
  • Lets the material breathe
  • Delays ageing and makes maintenance easier
USE
  • Porous materials: natural stone, terracotta, brick, concrete, etc.
  • Floors and facades
  • New or old
  • Interior or exterior

Surface preparation :

  • 1
    Apply the product to a clean, dust-free, grease-free and dry surface.
  • 2
    To remove stains and traces of pollution, use Guard Wash® or Guard Wash® Express.
  • 3
    To remove grease stains, use Net'Guard® Ultra 4 in 1.
  • 4
    To remove traces of efflorescence, laitance or grout film, use Guard Remover® Eco Efflorescence & Cement.
  • 5
    Rinse carefully until the surface is free of any trace of cleaner and let the surface dry.

Application :

  • Use the product in its pure form: do not dilute it.
  • Shake the package thoroughly before use.
  • Carry out a preliminary test on a small area.
  • Apply a first layer.
  • Wait for 15 to 30 min.
  • Apply a second layer.
  • Do not over apply, eliminate any exceeding product before drying.

For further information, refer to the data sheet and safety sheet.

  • Application: short-haired brush or brush for acrylic varnish.

  • 2KG

  • 5KG

  • Technical data sheet

  • Safety data sheet