ProtectGuard Wet Finish – Wet Look Sealer for Stone & Concrete – Stain & Water Protection – Plant-Based

Wet look sealer that enhances colour while protecting stone and concrete from water, oil and stains. Ideal for floors, patios and terraces, it provides long-lasting protection and keeps materials looking richer and easier to clean.

ProtectGuard Wet Finish is a plant-based wet look sealer designed to enhance colour while protecting stone and concrete from everyday damage.

It brings out deeper tones and gives materials a richer, “just wet” appearance, making surfaces look more vibrant and refreshed. Ideal for patios, terraces, driveways, pool surrounds and indoor floors, it transforms dull or faded areas into a more intense and uniform finish.

At the same time, it protects against water, oil and stains. Spills stay on the surface instead of soaking in, making cleaning easier and helping prevent marks caused by rain, grease or pollution. This helps keep floors looking clean for longer and reduces maintenance.

The product works without blocking the material. Stone and concrete remain breathable, so moisture can escape naturally without causing damage over time. The finish is UV-resistant and will not yellow, even with long-term outdoor exposure.

Suitable for materials such as natural stone, limestone, concrete, brick, terracotta or paving, it can be used both indoors and outdoors on floors and vertical areas.

The plant-based formula offers a more environmentally responsible alternative while maintaining high performance. Made with 52% ingredients from plant sources, it delivers long-lasting protection (up to 5 years) with a durable and non-slip finish.

Easy to apply with a roller or brush, ProtectGuard Wet Finish provides a simple way to enhance appearance and protect surfaces in one step.

Sales contact

Beading effect
Floors, facades
Coverage (1L = 10m²)

Back to the list

ProtectGuard Wet Finish Plant Based Formula 4L

Surface preparation :

1

Apply the product to a clean, dust-free, grease-free and dry surface.
2

To remove stains and traces of pollution, use Guard Wash® Express.
3

To remove grease stains, use Guard Cleaner® Degreaser.
4

To remove traces of efflorescence, laitance or grout film, use Guard Remover® Efflorescence & Cement.
5

Rinse carefully until the surface is free of any trace of cleaner and let the surface dry.

Application :

Use the product in its pure form: do not dilute it.
Shake the package thoroughly before use.
Carry out a preliminary test on a small area.
Apply a first layer.
Wait for 30 min. The 1st coat must be completely dry to the
touch before applying the second.
Apply a second layer.
Do not over apply, eliminate any exceeding product before drying.

For further information, refer to the data sheet and safety sheet.

Roller or wide brush
Apply preferably with a roller: • Smooth surface = 4 to 6 mm nap. • Textured surface = 6 to 8 mm nap. Can also be applied with a wide brush.

Technical data sheet
Safety data sheet

A project ? Contact a sales representative

Our sales teams support you throughout your project, from the choice of products to their implementation.

Sales contact

ProtectGuard Wet Finish – Wet Look Sealer for Stone & Concrete – Stain & Water Protection – Plant-Based

Surface preparation :

Application :

1L

5L

Technical data sheet

Safety data sheet

A project ? Contact a sales representative

Related products