Go back

ProtectGuard® CE

Water/oil-repellent and stain protection for concrete. Compliant with Standard EN 1504-2

ProtectGuard® CE provides long-lasting protection for all concretes against water, chlorides, corrosion and carbonation. It also prevents the main causes of deterioration like atmospheric pollution, grease stains, ingress, graffiti, etc. It slows down the ageing of the material and makes it easier to maintain.

ProtectGuard® CE is a non-film forming impregnation product, the material is still permeable to air and water vapour. Completely colourless after application, it does not change the appearance or the nature of the treated material. It is also fully resistant to UV rays and does not yellow over time.

ProtectGuard® CE is a concrete protection product with CE marking, compliant with Standard NF EN 1504-2, enabling all concrete structure protection requirements to be be met.

  • Beading effect
  • 10 years guarantee
  • Floors, facades
  • Coverage (1L = 10m2)
Advantages
  • Protection against water, stains and chlorides
  • Prevents corrosion of reinforcements
  • Compliant with Standard EN1504-2
  • Does not form a film, lets the material breathe
  • Invisible
  • UV and frost resistant
  • Delays ageing and makes maintenance easier
USE
  • All types of concrete: standard, reinforced, fibre, high-performance (UHPC, GRC)
  • Facades, walls and floors
  • New and old
  • Exterior and interior
Back to the list
Advantages
  • Protection against water, stains and chlorides
  • Prevents corrosion of reinforcements
  • Compliant with Standard EN1504-2
  • Does not form a film, lets the material breathe
  • Invisible
  • UV and frost resistant
  • Delays ageing and makes maintenance easier
USE
  • All types of concrete: standard, reinforced, fibre, high-performance (UHPC, GRC)
  • Facades, walls and floors
  • New and old
  • Exterior and interior

Surface preparation :

  • 1
    Apply the product to a clean, dust-free, grease-free and dry surface.
  • 2
    To remove traces of efflorescence, laitance or grout film, use Guard Cleaner® Surface Preparation.
  • 3
    To remove grease stains, use Guard Cleaner® Maintenance.
  • 4
    Rinse carefully until the surface is free of any trace of cleaner.

Application :

  • Use the product in its pure form: do not dilute it.
  • Shake the packaging well before use and carry out a preliminary test.
  • Apply the product to saturation in a single coat or two coats”wet on wet”.
  • Do not overload the material.
  • The surface must be protected for 24 hours (rain, grease, etc.).
  • Optimum efficiency of the product obtained after 7 days.

For further information, refer to the data sheet and safety sheet.

  • Apply using a low-pressure sprayer with viton joint, an airless sprayer, a roller or a brush.

  • 5L

  • 25L

  • Technical data sheet

  • Safety data sheet

A project ? Contact a sales representative

Our sales teams support you throughout your project, from the choice of products to their implementation.