Go back

ProtectGuard® WF Special Concrete

Water/oil-repellent and stain protection for concrete

ProtectGuard® WF Special Concrete is a water and oil-repellent treatment for concrete and UHPC. It protects against water ingress, oil and all types of stains. It makes maintenance of concrete easier and prevents the main causes of ageing like grease marks, ingress, etc.

ProtectGuard® WF Special Concrete is an environmentally-friendly product, completely in an aqueous phase (non toxic, oil-based solvent-free). ProtectGuard® WF Special Concrete is an impregnation product, the material remains permeable to air and water vapour. It is also is fully abrasion and UV resistant and does not yellow over time.

  • Beading effect
  • Floors, facades
  • Eco-friendly
  • Coverage (1L = 10m2)
Advantages
  • Protects against water, oil and stains
  • Does not form a film, lets the material breathe
  • Colourless
  • Available in matt and gloss finishes
  • Abrasion resistant
  • UV and frost resistant
  • Slows down ageing and makes maintenance easier
USE
  • All types of concretes: standard, reinforced, fibre, high-performance (UHPC, GRC)
  • Floors and facades
  • New and old
  • Internal and external
Back to the list
Advantages
  • Protects against water, oil and stains
  • Does not form a film, lets the material breathe
  • Colourless
  • Available in matt and gloss finishes
  • Abrasion resistant
  • UV and frost resistant
  • Slows down ageing and makes maintenance easier
USE
  • All types of concretes: standard, reinforced, fibre, high-performance (UHPC, GRC)
  • Floors and facades
  • New and old
  • Internal and external

Surface preparation :

  • 1
    Apply the product to a clean, dust-free, grease-free and dry surface.
  • 2
    To remove traces of efflorescence, laitance or grout film, use Guard Cleaner® Eco Surface Preparation.
  • 3
    To remove grease stains, use Guard Cleaner® Eco Maintenance.
  • 4
    Rinse carefully until the surface is free of any trace of cleaner.

Application :

  • Use the product in its pure form: do not dilute it.
  • Shake the package before use for 5 minutes to evenly distribute the matting agents.
  • Carry out a preliminary test.
  • ProtectGuard® WF Special Concrete is applied in 2 coats.
  • Apply an initial coat of the product over the entire surface area of the material.
  • Let it soak in and leave the product to dry (15 to 30 minutes depending on the porosity and temperature of the material) then apply a second coat.
  • Always ensure full treatment by wetting the surface with water after drying to check the material is correctly protected.
  • Do not overload the material, quickly remove any excess.
  • Dry before putting back into use: 24 hours.
  • Optimal efficiency reached after 5 to 7 days.

For further information, refer to the data sheet and safety sheet.

  • Apply with the applicator, short hair roller, HVLP sprayer or air-assisted air gun.

  • 5L

  • Technical data sheet

  • Safety data sheet

A project ? Contact a sales representative

Our sales teams support you throughout your project, from the choice of products to their implementation.