AntiGraffitiGuard^®

Permanent graffiti protection, oil/water repellent for concrete

AntiGraffiti Guard^® is a very high performance two-part anti-graffiti product. Formulated with new generation resins it is much more effective in terms of protection of all porous and low porous concrete against all kinds of graffiti or tags (paint, felt pens, etc.) and dirt.

AntiGraffiti Guard^® protects treated surfaces permanently. It can be cleaned dozens of times (using Guard Remover Graffiti^® 2010 graffiti cleaner) and will still keep working, so does not need to be reapplied after graffiti has been removed.

AntiGraffiti Guard^® is available in a flat or satin finish.

Sales contact

Beading effect
5 years guarantee
Facades
Eco-friendly
Coverage (1L = 8m²)

Back to the list

Surface preparation :

1

Apply the product to a clean, dust-free, grease-free and dry surface.
2

To remove traces of efflorescence, laitance or grout film, use Guard Cleaner® Surface Preparation.
3

To remove grease stains, use Guard Cleaner® Maintenance.
4

Rinse carefully until the surface is free of any trace of cleaner.

Application :

AntiGraffitiGuard® is prepackaged in the correct ratios. All of
component A must therefore be mixed with all of component B. Under no circumstances modify the A:B ratio.
Before use, thoroughly mix part A (base) using an electric stirrer until a homogeneous liquid is obtained.
Stirring continuously, add part B (hardener) to part A (base). Blend at moderate speed with an electric mixer for at least 5 min. Leave for 10 min. to allow bubbles to escape, then homogenise again with the electric mixer before application.
Once prepared, the mixture can be used for 2 hours at an ambient temperature of less than 20°C.

Applying the first coat in two layers:

In very hot weather: the first coat can be diluted to 10% in clean (drinking) water. Thoroughly homogenise the whole mixture.
Having first treated the substrate with PrimerGuard®, the product can now be applied to the substrate.
Leave to dry for 1 hour (assuming a temperature of 20°C).
Typical coverage on concrete: 60 to 100 g/m² (10 to 16 m²/litre).

Applying the second coat in two layers:

For better control and ideal results, it is recommended that the 2nd coat be applied with an HVLP spray gun.
Typical coverage on concrete: 60 to 100 g/m² (10 to 16 m²/litre).
Protected drying: 24 hours.
Optimal effects obtained after 5 to 7 days.

For further information, refer to the data sheet and safety sheet.

For better control and ideal results, it is recommended that be applied using an HVLP type spray gun with 4 bars pressure. Application with a roller or a brush is also possible.