Surface preparation :
-
1Always apply the product to clean, dust-free, sound and dry wood. • New wood: Sand with 80-120 grain and then remove dust. • Untreated or oily aged wood: Sand with 80-120 grit then dust and clean with WoodGuard® Revitalizer. Rinse the wood thoroughly then leave to dry for 48 hours. • Treated aged wood: Sand with 50-80 grit to remove all previous protection, then clean with WoodGuard® Revitalizer. Rinse the wood thoroughly and leave to dry for 48 hours.
Application :
Do not apply in rainy or very hot weather. Ideal air
and substrate temperature 10°C to 30°C.
Shake product A (base) thoroughly before use.
• Add part B (hardener) slowly to part A (base)
of
WoodGuard® Color AntiGraffiti, stirring
continuously. Use an electric stirrer to stir at medium
speed until the mixture is homogeneous (around 5
to 15 minutes depending on quantity).
• Leave the mixture exposed to the air for 15 to 30
min to allow bubbles to escape, then stir again for 1
min before use.
• The resulting mixture can be used for 4 hours if
the ambient temperature is below 25°C. If the
temperature is higher, the useable time will be
shorter. Do not use the mixture after this time.
Applying the 1st layer:
• Apply WoodGuard® Color AntiGraffiti diluted with
not more than 5 to 10% water. Mix thoroughly.
The first layer must be regarded as a primer layer
designed to both impregnate the wood and provide
a key for the next layer.
• Apply sparingly to avoid producing a thick film that
does not breathe.
• Leave to dry for 30 min to 1 hour at 20° C. The
substrate must be dry and non-tacky before it can
be reworked.
• For best results rub down before the second layer.
Applying the 2nd layer:
• Apply the second layer sparingly using undiluted
WoodGuard® Color AntiGraffiti.
• If a third layer is needed, repeat the procedure
described above. Wait until completely dry before
applying any additional layer.
• Protect from rain for 24 hours and from oily deposits
for at least 48 hours.
• Optimal performance is attained after 5 to 7 days.
-
5L
