Permanent anti-graffiti protection and water repellent for wood WoodGuard AntiGraffiti
Product application

APPLICATION

• Apply the product to a clean, dust-free and dry surface. Temperature needs to be > 10°C.
• If the surface needs to be cleared beforehand, we recommend using WoodGuard Revitalizer.
• Do not apply to wood which is varnished or polished.
• Do not apply during rain or excessive heat
• For wood which has been treated with a fire retardent carry out a trial on a small area.
• Thoroughly shake product A before use.

Application :

• Slowly add product B, stirring constantly, to product A. Use an electric mixer and keep stirring at moderate speed until you obtain a homogenous mix (approximately 5 to 15 minutes, depending on quantity).
• Let the mix rest 15 to 30 minutes, uncovered, and mix again for 1 minute before use.
• The resulting mix can be used for 6 hours at a room temperature of 25°C or below. If the temperature is higher, prepare the product in smaller quantities. Do not use the product after 6 hours. To control the application process and for best results, apply WoodGuard AntiGraffiti using a HVLP spray gun. You can also use a brush or roller.
• Apply evenly to avoid forming a thick, non-breathable coating.
• Protect from rain for 24 hours.
• Optimal protection obtained after 5 to 7 days.

1st coat :

• Apply WoodGuard AntiGraffiti diluted with water 5% to 10% maximum. Mix well. The first application will both soak into the wood and help the second application forms a film on the surface.
• Allow to dry for half an hour to an hour at 20°C. The first coat must be dry and non-sticky before you apply a second coat.

2nd coat :

• Lightly sand to obtain a smooth surface and remove any protruding wood fibres.
• Evenly apply a second coat using undiluted WoodGuard AntiGraffiti.
• If a third coat is necessary, repeat the instructions given for the second coat. Wait for the surface to be completely dry before applying any additional coat.

APPLICATION EQUIPMENT