Protection products

water repellent and stain repellent & wet-look finish for porous stone

ProtectGuard Wet-Look protects all porous building materials by giving treated substrates a 'wet look' finish that enhances the original colour.

  • ProtectGuard Wet-Look prevents water, stains and all types of soiling from penetrating mineral surfaces. A surface treated with ProtectGuard Wet-Look is easier to care for and will be protected against the main causes of deterioration such as atmospheric pollution, grease-based stains and penetration by liquids.
  • ProtectGuard Wet-Look is an environmentally friendly, completely water-borne product that is non-toxic and does not contain solvents.
  • ProtectGuard Wet-Look allows the substrate to remain permeable to air and water vapour as well as being UV resistant. It does not turn yellow over time.

ProtectGuard Wet-Look can be applied to vertical, horizontal, inside and outside surfaces. Can be used on all porous or very porous materials:

  • Natural stone, terracotta (floor-tiles), brick, limestone

Packaging

1 and 5 litres.

Coverage

  • Per 1 litre: 10 to 15 m2.

Average figures given for reference only. The actual quantity of product needed depends on the substrate’s porosity.

Properties :

  • PROTECTION AGAINST WATER FROST & DIRT
  • ANTI-STAIN & SOILING
  • DELAYS CLOGGING & AGING
  • ENHANCES COLOUR
  • ALLOWS THE SUBSTRATE TO BREATHE
  • HIGH UV RESISTANCE
  • FLOORS & WALLS
  • INTERIOR & EXTERIOR
  • QUICK & EASY TO USE

Further information :

- Product application
- Building project references

Finding a distributor



Ecological Product

ProtectGuard Wet Look is :

  • water-based
  • petroleum solvent-free
  • over 90% biodegradable
  • non-toxic
  • non-hazardous
  • non-flammable