POLYURETHANE AND EPOXY FLOOR COATINGS REMOVER
PRODUCT DESCRIPTION
DECAP’PEINTURES PLUS GUARD is a powerful remover that will remove alkyd, polyurethane and epoxy paints, varnishes and resins
DECAP’PEINTURES PLUS GUARD is principally designed for stripping indoor and outdoor floor coatings, e.g garage floors, cellars, patios…
CHARACTERISTICS
- Non-flammable
- Ready to use
- Easy to use
- Does not alter the treated surfaces appearance
- Can be applied to inside and outside surfaces
- Can be used on a large variety of supports
COVERAGE PER LITRE
The figures below are approximate and should be used only as a general guideline:
2 - 4 m² / litre
USAGE
This product is designed to strip paint and varnish-covered floors back down to their original state
- Preliminary testing on a small area before proceeding is strongly advised
- Use the product neat – never diluted
- If the packaging shows that the product is two-phase, mix well before using.
- Use a roller, flat paintbrush or a natural fibre brush to apply one thick application
- Allow 15 minutes to one hour for the product to act, depending on the coating type and the number of coats to be removed.
- Remove softened material using a knife
- Rinse with water using a high pressure power washer
PACKAGING
Cans : 5L, 20L.
To obtain the technical sheet, contact us with the contact form and do not forget to fill all the field.
SECURITY FACT SHEET >>>
SECURITY FACT SHEET >>>
To see our references, click here : References
Make a simulation to obtain the requested quantity of products litres by choosing a product, the kind of material to be treated and by defining the number of square metres of the surface area to be treated.
Document and photos are not contractual .
We are not responsible of a bad use of our products.
It is indispensable to proceed to preliminary attempts.
Guard Industrie SAS 300 000 Euros 7 rue Gutenberg 93108 - MONTREUIL CEDEX - FRANCE
Tel : +33 (0)1 55 86 17 60 - Fax. +33 (0)1 48 58 16 89
copyright ©guardindustrie.com - tous droits réservés