ProtectGuard Wet Look Flat

WATER REPELLENT – OIL REPELLENT
COMPLETE FLOORING PROTECTION WITH A PERMANENT Flat "WET LOOK"

PRODUCT DESCRIPTION

PROTECTGUARD Wet Look Flat is an all-in product offering both water and oil repellency protection to all porous building materials, and is particularly suited for flooring.

PROTECTGUARD Wet Look Flat can be used inside and outside on all porous materials such as natural stone, concrete, terracotta, cement and self-locking paving.

PROTECTGUARD Wet Look Flat is an environmentally friendly, completely water-borne product that is non-toxic and does not contain solvents or silicone. It is designed to protect all porous materials against water and oil penetration and all kinds of stains.

PROTECTGUARD Wet Look Flat is a non film-forming impregnation treatment that leaves the treated surface both air and water vapour permeable.

PROTECTGUARD Wet Look Flat gives a permanent matt ‘wet look’ finish to the treated surface and brings out the true colour. It is also UV resistant and does not discolor over time.

A surface treated with PROTECTGUARD Wet Look Flat makes for easier upkeep and helps solve the main causes of deterioration such as atmospheric pollution, grease-based stains and penetration of liquids

CHARACTERISTICS

Can be applied to vertical, horizontal, inside and outside surfaces
Prevents the penetration of water and oily liquids
Anti-staining, anti-dirt. Prevents chewing-gum from sticking to treated surfaces and stops dirt due to pollution from building up again. Limits moss and lichen growth.
Prevents deterioration resulting from the freeze-thaw cycle
Makes cleaning easier
Non film-forming, allows the surface to breathe
Non-hazardous and non-toxic
Water-borne product
Solvent and silicone-free
95% + biodegradable
UV-resistant, does not discolour
Invisible after drying
Ready to use
Easy to use
Non-flammable

COVERAGE PER LITRE

Coverage depends on the porosity of the material. The figures below are approximate and should be used only as a general guideline:
6 - 10 m² / litre

USAGE

Shake the container well before use
Make sure the surface to be treated is clean, dust-free and dry before applying the product
Use neat, do not dilute
Apply using a wide Spalter brush or a T-Bar and applicator sleeve
The surface to be treated should be impregnated up to saturation point (two applications "wet on wet")
Do not over-apply the product to the surface, remove any excess
Leave to dry for 24 hours before allowing traffic or people back onto the surface
For the optimim performance, wait 5 to 7 days

PACKAGING

Cans : 1L, 5L, 10L, 25L.

ProtectGuard Wet Look Flat

Respectful of Man and Environment.

To obtain the technical sheet, contact us with the contact form and do not forget to fill all the field.

SECURITY FACT SHEET >>>

To see our references, click here : References

Make a simulation to obtain the requested quantity of products litres by choosing a product, the kind of material to be treated and by defining the number of square metres of the surface area to be treated.

Home >> PROTECTION PRODUCTS >> ProtectGuard Wet Look Flat

Document and photos are not contractual .
We are not responsible of a bad use of our products.
It is indispensable to proceed to preliminary attempts.

Guard Industrie SAS 300 000 Euros 7 rue Gutenberg 93108 - MONTREUIL CEDEX - FRANCE
Tel : +33 (0)1 55 86 17 60 - Fax. +33 (0)1 48 58 16 89