Decorate and protect

Water repellent and stain repellent & colour for porous stone ProtectGuard Color
Product application

-> Back to the technical manual

PRECAUTIONS :

  • Do not dilute or mix with another product
  • Do not apply on organic, metallic and waterproof materials.
  • Do not apply during rain or frost and when surface and air temperature is < 5°C & > 30°C.
  • Keep in a dry place (between 5°C and 30°C).
  • Storage: 24 months following the production date when kept in the original unopened container.

APPLICATION

  • Substrates must always be clean, dustfree and dry.
  • Always test on a small hidden portion of the substrate before applying.
  • Shake the container well before use.
  • Use the product neat; do not dilute.
  • Apply with an HVLP-type spray unit (high volume, low pressure) in 2 to 4 crossed-over applications at maximum level depending on the desired appearance. Drying time between each application: 15 minutes. On very porous substrates, a short pile roller can be used.
  • On vertical substrates, always apply from the bottom up.
  • Do not over apply to the substrate, and remove all excess before drying.
  • Protected drying time: 24 hours.
  • Optimum effectiveness obtained after 7 days.
  • Clean equipment with water immediately after use.

It is recommended that the product be applied by a Guard Industry-authorised applicator.

For any additional information, you may refer to the ProtectGuard Color technical file available on demand by using the contact form

MAINTENANCE

Domestic stains can be cleaned with a scrubbing brush and clean water, to which a detergent with a neutral pH can be added such as Décap'Sols Guard Ecological.

APPLICATION EQUIPMENT



Use an HVLP spray unit, brush or roller.